100824 Site Visit

Assembly Hall gutters, to replace previous incorrect installation arrive on site

First AH gutter is moved into place by DGT. 

Water still pouring onto Assembly Hall floor.

Soffit of suspended Assembly Hall ceiling being installed with unistrut drops below for ductwork support and acoustic panel support.

Fixing of AH ceiling up to high level structure

Extent of AH ceiling at end of site visit with opening for rooflight

Otway House entrance hall with existing tiling below protective flooring, fixing of radiator R9 here to be clarified.

OH, fixing of radiator R12 on existing tiled floor

Floor joists in place on OH ground floor abutting windows to be boarded from inside

Insulation to Otway rafters not completed, insulation on site

Breather membrane and battens laid onto majority of Otway roof

Stepped central valley gutter, now in 5 bays, being formed

Rooflight openings adjacency to valley board. Note that bottom rooflight will be 150mm above shown opening.

Leadwork being prepared

Lead valley with brather membrane and eaves felt dressed over & into valley.

 Lightning conductor's contact with lead valley has been flagged up in site visit report.

Correct line of Otway eaves following amendments discussed with roofer at previous site visit

Reduced fascia board depth to achieve required last slate level with vent

Salvaged slates ready to be laid onto visible face of Otway roof

Classroom omnia mist coat, ongoing

Classroom omnia mist coat, ongoing

Classroom omnia mist coat, ongoing

Classroom omnia mist coat, ongoing

Back-to-back trunking chasing. To be reviewed with EHRW & MFLLP

Raked wall along Classroom gridline 1. Capping to be added. Area to check whether distance from capping to windpost is adequate.

Raked wall along Classroom gridline D. Area to check whether distance from capping to windpost is adequate.

Otway - Assembly link at first floor. Steel installation internally and externally to be checked with respect to protecting the adjacent voussoirs arch (out of picture)

300x200 flush access panel at high level required in Otway at riser 2.

small 150x150 flush access panel at low level . NB. If control levers (above) can be moved to this level then one hatch would be preferable and more convenient for maintenance.